2012 Ram C/V Cargo Van Alignment: Specs & Service

Have the alignment checked after a major pothole impact, suspension repairs, or steering-component replacement. An alignment measurement can confirm whether the wheels remain within factory specification before an adjustment is recommended. This approach helps avoid paying for an adjustment when the angles are already correct.

• Check alignment after a significant road impact.
• Inspect alignment after suspension or steering work.
• Use measured angles to determine whether adjustment is needed.

These symptoms can occur when wheel angles are outside the manufacturer's specification. Larry H. Miller Dodge Ram Peoria can measure all four wheel positions and inspect related tires, steering, and suspension components. A measurement helps separate an alignment concern from a worn part that may prevent the setting from holding.

• The van pulls on a flat road.
• The steering wheel is not centered while driving straight.
• A tire wears more quickly along one edge.

The service begins with an inspection of tires, steering, and suspension components that could affect alignment. The technician measures the current angles, makes permitted adjustments, and explains whether the results indicate an alignment correction is needed. This process gives you measured information before adjustment work is performed.

• Camber, caster, and toe measurement on all four wheels.
• Inspection of tires, steering, and suspension components.
• Adjustment toward the manufacturer's specification where the suspension allows.

A technician should check the suspension and steering components before setting the wheel angles. Excessive wear can change the measured position while the van is moving, so an alignment alone may not correct the underlying concern. Larry H. Miller Dodge Ram Peoria will explain what the inspection finds before recommending related work.

• Inspect tie rods for wear.
• Check ball joints and strut-related components.
• Confirm the suspension can hold the adjusted angles.

Alignment angles can be checked before deciding whether an adjustment is necessary. That measurement helps identify uneven settings that may affect tire wear even when the steering feels normal. It also provides a clear starting point after suspension or steering work.

• Measure before authorizing an adjustment.
• Look for uneven tread wear during inspection.
• Recheck after major pothole or suspension impact.

The results show whether an adjustment is needed before you pay for one. The inspection also looks for tire, steering, and suspension wear that could contribute to pulling or uneven tread wear. Schedule service with Larry H. Miller Dodge Ram Peoria for a measurement-based evaluation of your van.

• Compare current wheel angles with factory specification.
• Identify conditions that can hold alignment out of specification.
• Determine whether adjustment is appropriate.

Inspection also covers tires, steering, and suspension components that may hold an alignment out of specification. A pull, off-center steering wheel, or uneven edge wear can indicate that the measured angles need attention. Worn components may need to be addressed before an alignment can hold properly.

The van's 4,510-pound curb weight and commercial cargo purpose make tire condition and straight tracking useful areas to monitor during service. Larry H. Miller Dodge Ram Peoria in Peoria, AZ, can measure the current angles and explain whether adjustment is needed. Bring your 2012 Ram C/V Cargo Van to Larry H. Miller Dodge Ram Peoria in Peoria for a factory-spec alignment — schedule service.

The technician compares the current angles with the manufacturer's specification and adjusts them where the suspension allows. This helps identify whether the concern is an alignment setting or a worn component such as a tie rod, ball joint, or strut. Measuring first also helps determine whether an adjustment is needed before work is authorized.

Visit Larry H. Miller Dodge Ram Peoria at 8665 West Bell Road, Peoria, AZ 85382. For directions or assistance, call 623-400-7471, or schedule service online.