2013 Dodge Charger Alignment: Specs & Service

An alignment check is useful when the Charger pulls on a flat road, the steering wheel is off center, or tire tread wears unevenly. It is also sensible after suspension work or a major pothole impact. Larry H. Miller Dodge Ram Peoria can measure the current angles before recommending an adjustment.

• Check alignment after noticeable impact damage.
• Watch for one-edge tire wear.
• Compare steering-wheel position while driving straight.

These symptoms can indicate that the wheels are not tracking within the manufacturer's specifications. The alignment inspection measures camber, caster, and toe on all four wheels. Tire, steering, and suspension components are also checked for wear that could keep the alignment from holding.

• Vehicle pulls left or right on a flat road.
• Steering wheel is not centered while driving straight.
• Tread wears unevenly across a tire.

The technician inspects tires, steering, and suspension components for wear that could affect the result. Booking first provides current angle measurements, so you can learn whether an adjustment is needed before paying for one. The service focuses on correcting wheel angles that contribute to pulling and uneven tread wear.

• Camber, caster, and toe measurement.
• Inspection of tires, steering, and suspension.
• Adjustment toward manufacturer specification where the suspension allows.

The inspection looks for tire, steering, and suspension wear before an adjustment is recommended. Components such as tie rods, ball joints, or struts may need attention if they are worn, although the inspection determines the actual cause. Larry H. Miller Dodge Ram Peoria can explain whether the measured angles point to an adjustment or a related repair.

• Inspect steering components for looseness or wear.
• Check suspension components that affect wheel angles.
• Review measured angles before adjustment decisions.

A Charger that tracks straight may not need an immediate adjustment, but a measurement can confirm its current wheel angles. The service identifies whether camber, caster, or toe is outside the manufacturer's specification where adjustment is possible. This helps avoid paying for an adjustment that the measurements do not support.

• Use symptoms to decide when to request an inspection.
• Check alignment after suspension-related work.
• Measure angles before authorizing an adjustment.

The service measures all four wheel angles and checks the tires, steering, and suspension for conditions that could affect alignment. Booking lets the technician compare current angles with the manufacturer's specifications before an adjustment is recommended. Use the schedule service page to request an appointment.

• Location: 8665 West Bell Road, Peoria, AZ 85382.
• Dealer: Larry H. Miller Dodge Ram Peoria.
• Phone: (623) 400-7471.

The technician then measures camber, caster, and toe on all four wheels. Where the suspension allows, the angles are adjusted back toward the manufacturer's specification. Booking provides current measurements against the factory reference, so you can learn whether an adjustment is needed before paying for one. The service addresses the wheel angles that can cause tire scrub, uneven tread wear, pulling, or an off-center steering wheel.

Because no routine alignment interval is established in the manufacturer's maintenance schedule for this model year, symptoms and impact history are useful reasons to request an inspection. Schedule service online or call (623) 400-7471 at Larry H. Miller Dodge Ram Peoria.

Larry H. Miller Dodge Ram Peoria is located at 8665 West Bell Road in Peoria, Arizona. The service measures camber, caster, and toe across all four wheels, then determines whether adjustment toward the manufacturer's specification is appropriate. Tire, steering, and suspension inspection is part of the process because worn components can affect alignment results.

For local assistance, schedule service online or call (623) 400-7471. The dealership is at 8665 West Bell Road, Peoria, AZ 85382.

All four wheels are measured, and adjustments are made back toward the manufacturer's specification where the suspension allows. The inspection also covers tires, steering, and suspension components that may keep the vehicle out of alignment. If a component is worn, correcting the angles alone may not resolve the concern or may not hold.

For a factory-spec measurement and an adjustment recommendation based on the current angles, bring your 2013 Dodge Charger to Larry H. Miller Dodge Ram Peoria in Peoria. Schedule service online or call (623) 400-7471.