2018 Ram 1500 Alignment: Specs & Service

Those time and mileage points are reminders rather than a substitute for checking how the truck drives. The 2018 Ram 1500 can benefit from an inspection when steering behavior or tire wear changes. Larry H. Miller Dodge Ram Peoria can measure the current angles against factory specifications before recommending adjustment.

• Schedule an inspection after suspension component replacement.
• Consider service after a significant pothole impact.
• Use tire wear and steering behavior as practical warning signs.

Wheels that are out of alignment scrub the tires as the truck rolls, which can create uneven tread wear. You may notice the steering wheel is not centered while driving straight on a flat road. A measurement at Larry H. Miller Dodge Ram Peoria helps identify whether camber, caster, or toe needs attention.

• The truck pulls left or right on a flat road.
• The steering wheel sits off center while driving straight.
• One tire edge wears faster than the other.

The service begins with inspection of the tires, steering, and suspension for wear that could hold the alignment out of specification. The technician measures the current angles and identifies whether an adjustment is appropriate. This process applies across the 2018 Ram 1500 lineup, including Quad Cab and Crew Cab configurations.

• Camber, caster, and toe measurement on all four wheels.
• Adjustment toward factory specification where permitted.
• Inspection for tire, steering, and suspension wear.

An alignment may not correct the underlying problem when a steering or suspension component has excessive wear. Larry H. Miller Dodge Ram Peoria inspects the related components so you can learn whether an adjustment is appropriate. The technician can explain the condition found before additional work is authorized.

• Inspect tie rods for wear or looseness.
• Check ball joints and struts before alignment adjustment.
• Confirm whether the alignment can hold specification.

If the 2018 Ram 1500 tracks straight and the tires wear evenly, an alignment may not be necessary every time the tires are serviced. Symptoms such as pulling, an off-center wheel, or one-sided tread wear are stronger reasons to request measurements. Larry H. Miller Dodge Ram Peoria can determine whether adjustment is needed before payment for an alignment.

• Measure angles when steering behavior changes.
• Check tire wear for evidence of uneven contact.
• Inspect after steering or suspension repairs.

This approach helps separate an alignment concern from a worn tire, steering part, or suspension component. It also gives you a clearer basis for deciding whether service is needed. Schedule service with Larry H. Miller Dodge Ram Peoria in Peoria, AZ, for an inspection focused on the truck’s current condition.

• Measure all four wheel angles.
• Compare readings with manufacturer specifications.
• Identify whether adjustment or further inspection is appropriate.

When the suspension permits adjustment, the angles are returned toward the manufacturer’s specifications. The work is intended to address the way the wheels contact the road, helping reduce tire scrubbing and steering pull caused by misalignment. A final road evaluation can help confirm the truck’s steering response after service.

Because component wear can affect alignment results, inspection findings are important to the service decision. If a tie rod, ball joint, strut, tire, or other related part needs attention, the condition should be addressed so the alignment has a better chance of holding. Schedule service with Larry H. Miller Dodge Ram Peoria at 623-400-7471.

Symptoms can result when a wheel angle moves out of specification. Toe can contribute to tire scrub, while camber may produce wear on one tread edge. Caster affects steering feel and the tendency of the wheel to return toward center. A suspension inspection is performed before adjustment so worn components do not obscure the cause of the concern.

The service focuses on measuring the current condition and making permitted corrections toward factory specification. Bring your 2018 Ram 1500 to Larry H. Miller Dodge Ram Peoria in Peoria for a factory-spec alignment — schedule service.

Larry H. Miller Dodge Ram Peoria serves drivers at 8665 West Bell Road in Peoria, AZ 85382. The service team examines the tires, steering, and suspension before measuring camber, caster, and toe on all four wheels. That process helps identify whether the truck needs an adjustment or whether a worn component should be addressed first.

For directions or appointment assistance, contact Larry H. Miller Dodge Ram Peoria at 623-400-7471. You can also schedule service online for your 2018 Ram 1500.