2024 Ram ProMaster EV Delivery Van Alignment: Specs & Service

Road impacts can change wheel angles even when damage is not immediately visible. An inspection is also appropriate when the van pulls, the steering wheel is off center, or tire wear becomes uneven. The manufacturer’s maintenance schedule does not establish an alignment interval for this model year.

• Consider an alignment after suspension component replacement.
• Have the angles checked after a significant pothole impact.
• Use tire wear and steering behavior as practical warning signs.

Wheels outside specification can scrub the tires as the van travels, accelerating wear along one edge. Vibration at speed can also be a reason to request an inspection, although other tire or wheel concerns may cause it. Larry H. Miller Dodge Ram Peoria can measure the current angles before recommending an adjustment.

• Vehicle pulls on a flat road.
• Steering wheel sits off center while driving straight.
• One tire edge wears faster than the other.

The service begins with an inspection of the tires, steering, and suspension components for wear that could prevent the alignment from holding. Current angles are measured against the factory specification, so you learn whether an adjustment is needed before paying for one. This approach helps separate an alignment concern from a worn component.

• Camber, caster, and toe measurement.
• Adjustment where the suspension allows.
• Inspection for tire, steering, and suspension wear.

A suspension and steering inspection should come before an adjustment when the vehicle continues to pull or the tires keep wearing unevenly. Larry H. Miller Dodge Ram Peoria can identify component wear that may affect alignment results. You receive the inspection findings so you can decide whether additional work is appropriate.

• Inspect tie rods for wear.
• Check ball joints and struts.
• Confirm that suspension condition can support the alignment.

It becomes more worthwhile after a noticeable pothole impact, suspension work, or a change in steering feel. Measuring the angles provides a fact-based check instead of assuming an adjustment is necessary. The inspection also looks for tire, steering, and suspension wear that could affect handling or tire life.

• Check the steering wheel position while driving straight.
• Look for uneven tread wear.
• Request measurement after a major road impact.

The service measures the four wheel angles against the factory specification and checks related tires, steering, and suspension components. To arrange an appointment, use the schedule service page or contact the dealership at 623-400-7471. You can also review current service specials.

• Dealer: Larry H. Miller Dodge Ram Peoria.
• Address: 8665 West Bell Road, Peoria, AZ 85382.
• Phone: 623-400-7471.

Because the van uses front-wheel drive, accurate front-end geometry is important to steering feel and tire wear. The service is designed to identify whether the current angles need adjustment before any adjustment is recommended. A vehicle that pulls on a flat road, has an off-center steering wheel, or wears a tire edge faster than the other may benefit from measurement. Bring your 2024 Ram ProMaster EV Delivery Van to Larry H. Miller Dodge Ram Peoria in Peoria for a factory-spec alignment — schedule service.

The inspection matters because out-of-alignment wheels can scrub the tires while the van rolls, creating uneven tread wear and pulling the steering off center. Booking service gets the current angles measured against the factory specification, so you learn whether an adjustment is needed before paying for one. Review the service specials, then schedule service or call 623-400-7471.

The 2024 Ram ProMaster EV Delivery Van is an electric front-wheel-drive van with a single-speed direct-drive transmission and 463 cubic feet of cargo behind the rear seats. For alignment assistance, contact Larry H. Miller Dodge Ram Peoria at 623-400-7471 or use the service scheduler. The dealership is located at 8665 West Bell Road, Peoria, AZ 85382.