2025 Ram ProMaster EV Step Van Alignment: Specs & Service

Alignment checks are appropriate when the vehicle pulls, the steering wheel is off center, or tire tread wears unevenly. An inspection is also sensible after suspension work or a major pothole impact. Larry H. Miller Dodge Ram Peoria can measure the current angles against factory specifications before an adjustment is recommended.

• Check alignment after a significant pothole impact.
• Inspect after suspension component replacement.
• Watch for uneven wear across either tire edge.

On a flat road, the 2025 Ram ProMaster EV Step Van should not consistently drift left or right. A steering wheel that remains turned while driving straight can indicate an angle problem. Uneven tread wear may also show that the wheels are scrubbing the tires as the vehicle rolls.

• Vehicle pulls to one side on a flat road.
• Steering wheel sits off center when driving straight.
• One edge of a tire wears faster than the other.

The service begins with an inspection of the tires, steering, and suspension components for wear that could prevent the alignment from holding. The current angles are measured before any adjustment is recommended. This gives the driver a clear basis for deciding whether an adjustment is needed.

• Camber, caster, and toe measurement on all four wheels.
• Inspection for worn tires, steering, or suspension components.
• Adjustment toward manufacturer specification where possible.

An alignment measures wheel angles, but it cannot correct a component that is loose or worn. Larry H. Miller Dodge Ram Peoria inspects the steering and suspension for conditions that could move the angles out of specification again. The technician can explain whether the vehicle needs an alignment, component service, or both.

• Inspect tie rods for wear or looseness.
• Check ball joints and struts before adjustment.
• Identify tire wear that may point to a component concern.

A measurement is especially useful after a major pothole impact, suspension work, or a new symptom. Booking service lets the technician compare the current angles with factory specifications before charging for an adjustment. That approach helps determine whether alignment work is necessary for the 2025 Ram ProMaster EV Step Van.

• Consider measurement after a major road impact.
• Look for even tread wear across each tire.
• Check the steering wheel position while driving straight.

When wheels are out of alignment, they can scrub the tires as the vehicle rolls. That may create uneven tread wear and cause the steering to pull or sit off center. Larry H. Miller Dodge Ram Peoria measures all four wheels so the need for adjustment can be evaluated using the vehicle's current angles.

• Reduce uneven tire scrubbing caused by incorrect angles.
• Help identify pulling on a flat road.
• Evaluate steering and suspension condition during inspection.

Next, the technician measures camber, caster, and toe on all four wheels. These angles describe how each wheel sits in relation to the road and the vehicle. Where the suspension allows, the angles are adjusted toward the manufacturer's specification. Measuring before adjustment helps show whether the vehicle needs alignment work rather than assuming it does.

The result is a clearer assessment of the vehicle's current condition. If worn steering or suspension parts are found, they should be addressed because an alignment alone cannot make a loose component hold its setting. Schedule service at Larry H. Miller Dodge Ram Peoria for assistance.

Adjustment is performed back toward factory specification where the suspension allows. The inspection also considers tires, steering components, and suspension parts that may cause the angles to change or prevent a lasting result. A vehicle that pulls, has an off-center steering wheel, or shows one-edge tire wear should be evaluated rather than corrected by guesswork.

For the 2025 Ram ProMaster EV Step Van, booking an alignment provides a measurement of the current angles before an adjustment is recommended. Bring your 2025 Ram ProMaster EV Step Van to Larry H. Miller Dodge Ram Peoria in Peoria for a factory-spec alignment — schedule service.

Larry H. Miller Dodge Ram Peoria at 8665 West Bell Road in Peoria, AZ, measures camber, caster, and toe on all four wheels and adjusts toward manufacturer specification where the suspension allows. This gives drivers a fact-based answer about whether an adjustment is needed for their 2025 Ram ProMaster EV Step Van.

Contact the service department at 623-400-7471 or schedule service online. The dealership can help evaluate pulling, off-center steering, uneven tire wear, and other alignment concerns.